Demo. This is a one page demo of what a larger site would look like.Get a site like thisSee all designs
Blackridge Pool MechanicsPumps, heaters, remodels (702) 555-0171
Pool equipment repair, Henderson NV

Pumps, Heaters and Filters, Fixed Right.

We are the pool techs other pool services call when the equipment pad quits. We test, find the failed part and tell you if it is worth fixing before we touch a wrench.

Troubleshoot My PoolCall a Tech
Same dayMost pump repairs
$89Diagnostic, off the repair
1 yearParts and labor warranty
Blackridge tech testing a variable speed pump at an equipment pad behind a block wall
Pump motorWe read the amp draw here first. A hum with no spin is most often the start capacitor, about $180 to $320 to fix.
Return lineClean water goes back to the pool through here. Weak flow at the jets starts at a dirty filter or an air leak before the pump.
Filter valveSets filter, backwash or waste. A worn gasket here leaks at the pad and lets the pump lose its prime.
Pad check, Green ValleyTap a part to see what we test
Pool pump and heater troubleshooter

What Is Your Equipment Doing?

Pick the symptom and tell us a little about the pump. You get the likely part, repair or replace, a price range and what a variable speed pump would save you.

Symptom
Pump type
9 yrs
8 hrs
Likely partRepair

Start capacitor

Price range$180 to $260
Time on siteAbout 1 hour
Variable speed pump savings
Your pump$0
Variable speed$0
$0 a year
A range for planning, not a quote. We confirm with a meter and a written price before any work. Book a Diagnostic

The Equipment Pad, Taken Apart

Pump motor and wet end split apart for a shaft seal change
Pumps

Seals, Bearings and Motors

A worn shaft seal drips, then rusts the motor. We catch it early, swap the seal and o rings and check the impeller while it is open.

$180 to $550Motor swap from $650
Tech checking the burner tray of a gas pool heater
Heaters

Gas Heaters and Heat Pumps

Igniters, flame sensors, pressure switches and boards. Desert heat and dust are hard on them, so we clean the burners on every call.

$180 to $650New heater from $3,800
Water dripping from a union fitting onto the pad
Plumbing

Leaks at the Pad

Cracked unions, split valves and sun baked pvc. We replumb with fresh fittings and pressure test before we leave.

$150 to $500Full pad replumb quoted
Tech testing wires in a pool equipment subpanel with a clamp meter
Electrical

Breakers, Timers and Automation

Tripping breakers, dead timers and automation that lost its mind after a monsoon. Tested with a meter, never guessed.

$140 to $480Automation installs quoted
Remodeled pool at dusk with glass tile, travertine deck and lights on
Remodels

When It Is Time for More Than a Part

New tile, new plaster, a new pad and lights that work. One crew plans the equipment and the finish together.

  • Waterline tileGlass or porcelain
  • InteriorPlaster or pebble
  • DeckTravertine or resurface
  • EquipmentVariable speed, new filter
  • LightsColor LED, app control

Recent Pads and Pools

Tap any photo to see it big. On your site these are your own job photos.

Finished remodel at dusk with the mountains lit up Leak found at a pump union Seal kit laid out on a rag Testing a pump at an equipment pad Heater with the panel off Checking amps at the subpanel

Henderson to Summerlin

  • Henderson Home base
  • Green Valley Daily
  • Anthem Daily
  • Seven Hills Daily
  • Inspirada Daily
  • Boulder City Tue and Fri
  • Las Vegas Daily
  • Spring Valley Daily
  • Enterprise Daily
  • Summerlin Mon and Thu

From Pool Owners

4.9
★★★★★264 Google reviews

Two companies wanted to sell me a new pump. He found a bad capacitor, fixed it for under $200 and showed me the meter reading.

Dean C. Green Valley

Swapped our old single speed for a variable speed. The summer power bill dropped enough that we noticed the first month.

Maria L. Anthem

Heater kept clicking with no flame. Turned out to be a dirty filter tripping the pressure switch. Honest and quick.

Steve O. Boulder City

Sample reviews written for this demo. Your site shows your real Google reviews, word for word.

Repair Questions

Should I repair my pool pump or replace it?

If the pump is under eight years old, a seal, capacitor or bearing repair usually makes sense. If it is older and single speed, a new variable speed pump often costs less over a few years because it uses far less power.

How much can a variable speed pump save in Henderson?

It depends on your hours and power rate. A single speed pump running eight hours a day can use over $600 of power a year here. A variable speed pump running longer at low speed often uses a quarter of that.

Why does my pool heater click but not light?

Most often the pressure switch is not closing because the filter is dirty or flow is low. It can also be the igniter, flame sensor or gas supply. We test each one in order so you only pay for the part that failed.

Do you work on all pump and heater brands?

Yes. We carry common seals, capacitors, motors and igniters on the truck, so many repairs finish on the first visit.

How long does a pool remodel take?

A new waterline tile and deck resurface takes about two to three weeks. A full replaster with new equipment runs four to six weeks, weather and permits allowing.